Replacing The Fresh Air Filter; Replacing The Water Filter - LG LFX31925ST Owner's Manual
Super-capacity 3 door french door refrigerator with smart cooling technology
Hide thumbs
Also See for LFX31925ST:
- User manual ,
- Owner's manual (180 pages) ,
- Manual del propietario (50 pages)
Table of Contents
Advertisement
Replacing the Fresh Air Filter
It is recommended that you replace the air filter:
Approximately every six months.
When the CHANGE FILTER light turns on.
1
Remove the Old Filter
Turn the filter cover to the left to detach
from the refrigerator wall. The filter is
located on the inside of the filter cover.
Remove the filter from the cover and
replace it with a new filter.
2
Install a New Air Filter.
Place the new filter inside of the cover
with the side that says "Front" facing
outward. Turn the filter cover to the right
to attach to the refrigerator wall.
After changing the filter, push and hold the
Air Filter button for three seconds to reset
the filter sensor.
Replacing the Water Filter
It is recommended that you replace the water
filter:
Ap proximately every six months.
When the water filter indicator turns on.
When the water dispenser output
decreases.
When the ice cubes are smaller than normal.
Before Replacing the Water Filter:
If the top shelf, located below the water filter,
is in the highest position, it will need to be
removed prior to replacing the water filter.
To remove any shelf—Tilt up the front of the
shelf in the direction of
direction of
. Pull the shelf out.
MAINTENANCE
39
and lift it in the
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the LFX31925ST and is the answer not in the manual?
Questions and answers
water under the GLIDE N SERVE DRAWER
To fix water under the Glide N' Serve drawer in the LG LFX31925ST refrigerator, follow these steps:
1. Check for Blocked Drain – Excess moisture can accumulate if the refrigerator's defrost drain is clogged. Locate and clear any blockage in the drain hole at the back of the fridge.
2. Inspect Door Seals – Ensure the refrigerator door seals are clean and properly closed to prevent excess humidity from entering.
3. Adjust Temperature Settings – Verify that the refrigerator is set to the recommended temperature (typically around 37°F or 3°C) to minimize condensation.
4. Wipe and Dry Area – Remove the Glide N' Serve drawer and clean the water using a dry cloth. Check for any visible leaks.
5. Check Food Storage – Ensure food items are covered properly to reduce moisture buildup.
If the issue persists, consider contacting customer support for further assistance.
This answer is automatically generated