Install Power Supply Fan Module - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 2 HP NetServer LH 3000/3000r: Installing a Power Supply and Fan
4. From the front of the NetServer, pull the NetServer forward until
you hear the locking device engage with a click.
5. Remove the top cover by loosening the thumbscrew and lifting the
cover away from the NetServer.

Install Power Supply Fan Module

The redundant power supply fan module allows the NetServer to keep operating in
case the original fan fails.
1. Locate the power supply fan module, and press down on the tab to unlock
the hinged handle. As shown in Figure 2-1, this tab locks the handle in the
closed position.
Press down on the tab
to unlock the hinged handle.
Figure 2-1. Unlock the Hinged Handle on the Power Supply Fan Module
2. Locate the panel where you will insert the redundant power supply fan
module shipped with this upgrade kit. See Figure 2-2. As you insert the fan
module, this hinged panel rotates up and out of the way.
3. With the hinged handle open, insert the power supply fan module as shown
in Figure 2-2.
6