Introduction; Installation Overview - HP D7171A - NetServer - LPr Manual

1 Introduction

Installation Overview

This guide describes the tools required and the procedure for converting the HP
NetServer LH 3 (the pedestal configuration) to the HP NetServer LH 3r (the
rack-mountable configuration.)
Briefly, the conversion takes several steps:
1. Gather the tools and documentation needed to perform the conversion.
2. Remove the Bezel and the Rack Rail Cover, Hard Disk Drives, and Power
Supply Modules.
3. Move the NetServer to a bench area and position it on its side. Remove
the casters from the NetServer and install any additional memory or
accessory cards. Attach the rack mounting handles to the NetServer.
4. Remove the plastic lock pawl (which engages and secures the bezel lock
mechanism) from the NetServer chassis front. Unfasten the control panel
from the chassis and reorient it, then secure it to the chassis again. Install
the control panel bezel
5. Install the rails in the rack.
6. Install the LH 3r in the rack.
7. Install the bezel hinge and latch plate to the front of the NetServer. Install
the LH 3r bezel.
Once the LH 3 has been converted to the LH 3r configuration, you should refer to
the documentation listed below:
HP NetServer LH 3/LH 3r User Guide
HP NetServer LH 3 and LH 3r Installation Road Maps
HP NetServer LH 3 Technical Reference Card
HP NetServer Online Documentation CD-ROM
All documentation that comes with your rack, such as the HP Rack
Installation Road Map
The Rack Cabling Reference for the HP NetServer LH 3r
3