Page 45
CD(Black) Left Audio Channel Ground Ground Right Audio Channel P5PL2 Internal Audio Connectors AAFP P5PL2 Analog Front Panel Connector 2-25...
Page 46
USB78 USB56 P5PL2 USB 2.0 Connectors GAME P5PL2 Game connector 2-26...
Page 47
CPU_FAN PWR_FAN CPU FAN PWR CPU FAN IN +12V CPU FAN PWM Rotation CHA_FAN1 +12V Rotation P5PL2 Fan Connectors CHASSIS Chassis Signal +5VSB_MB (Default) P5PL2 Chassis Intrusion Connectors 2-27...
Page 48
+12 Volts +5 Volts +5V Standby +5 Volts +12V DC +12V DC Power OK -5 Volts Ground Ground +5 Volts Ground Ground Ground +5 Volts PSON# Ground Ground +3 Volts -12 Volts +3 Volts +3 Volts P5PL2 ATX Power Connectors 2-28...
Page 49
PLED SPEAKER PANEL RESET IDE_LED PWRSW Requires an ATX power supply. P5PL2 System Panel Connector • • • • • 2-29...
Page 58
• • A:\>afudos /oOLDBIOS1.rom A:\>afudos /oOLDBIOS1.rom AMI Firmware Update Utility - Version 1.19 (ASUS V2.07(03.11.24BB)) Copyright (C) 2002 American Megatrends, Inc. All rights reserved. Reading flash ..done Write to file ..ok A:\>...
Page 59
A:\>afudos /iP5PL2.rom A:\>afudos /iP5PL2.ROM AMI Firmware Update Utility - Version 1.19 (ASUS V2.07(03.11.24BB)) Copyright (C) 2002 American Megatrends, Inc. All rights reserved. WARNING!! Do not turn off power during flash BIOS Reading file ..done Reading flash ..done Advance Check ..
Page 60
A:\>afudos /iP5PL2.ROM AMI Firmware Update Utility - Version 1.10 Copyright (C) 2002 American Megatrends, Inc. All rights reserved. WARNING!! Do not turn off power during flash BIOS Reading file ..done Reading flash ..done Advance Check ..Erasing flash ..done Writing flash ..
Page 61
Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Floppy found! Reading file “P5PL2.ROM”. Completed. Start flashing...
Page 62
Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Floppy not found! Checking for CD-ROM... CD-ROM found. Reading file “P5PL2.ROM”. Completed. Start flashing...
Page 68
[1.44M, 3.5 in] select a field. Use [+] or [-] to Primary IDE Master [ST320413A] configure system time. Primary IDE Slave [ASUS CD-S520/A] Third IDE Master [Not Detected] Third IDE Slave [Not Detected] Fourth IDE Master [Not Detected] Fourth IDE Slave...
Page 69
Language [English] Use [+] or [-] to Primary IDE Master :[ST320413A] configure system time. Primary IDE Slave :[ASUS CD-S340] Secondary IDE Master :[Not Detected] Secondary IDE Slave :[Not Detected] Third IDE Master :[Not Detected] Fourth IDE Master...
Page 70
Legacy Diskette A [1.44M, 3.5 in] Use [+] or [-] to Primary IDE Master [ST320413A] Primary IDE Slave [ASUS CD-S520/A] configure system time. Third IDE Master [Not Detected] Third IDE Slave [Not Detected] Fourth IDE Master [Not Detected]...
Page 71
Primary IDE Master Select the type Device : Hard Disk of device connected Vendor : ST320413A to the system. Size : 20.0GB LBA Mode : Supported Block Mode : 16 Sectors PIO Mode Async DMA : MultiWord DMA-2 Ultra DMA : Ultra DMA-5 SMART Monitoring: Supported Type...
Page 72
IDE Configuration When in AHCI/RAID mode SATA Configure SATA As [Standard IDE] controller is Onboard IDE Operate Mode [Enhanced Mode] forced to Native Enhanced Mode Support On [S-ATA] mode. IDE Detect Time Out (Sec) [35] 4-16...
Page 74
AMIBIOS Version : 0107 Build Date : 09/08/05 Processor Type : Genuine Intel(R) CPU 3.20GHz Speed : 3200 MHz Count System Memory Total : 1024MB Appropriated : 0MB Select Screen Available : 1024MB Select Item Change Option General Help Save and Exit Exit 4-18...
Page 75
JumperFree Configuration Adjust system USB Configuration frequency/voltage. CPU Configuration Chipset Onboard Devices Configuration PCIPnP Configure System Frequency/Voltage Select the targe CPU frequency, and the AI Overclocking [Auto] relevant parameters will be auto-adjusted. Frequencies higher than CPU manufacturer recommends are not guaranteed to be stable.
Page 78
USB Configuration Enables USB host controllers. Module Version - 2.24.0-F.4 USB Devices Enabled: None USB Function [Enabled] Legacy USB Support [Auto] USB 2.0 Controller [Enabled] 4-22...
Page 79
Sets the ratio Configure Advanced CPU settings between CPU Core Manufacturer: Intel Clock and the FSB Brand String: Genuine Intel(R) CPU 3.20GHz Frequency. Frequency : 3200 MHz NOTE: If an invalid FSB Speed : 800 MHz ratio is set in CMOS then actual and Cache L1 : 16 KB...
Page 80
Advanced Chipset Settings Enable or disable DRAM timing. Configure DRAM Timing by SPD [Enabled] Hyper Path 3 [Auto] DRAM Throttling Threshold [Auto] Booting Graphic Adapter Priori [PCI Express/PCI] PEG Buffer Length [Auto] Link Latency [Auto] PEG Root Control [Auto] PEG Link Mode [Auto] Select Screen Slot Power...
Page 82
Configure Win627EHF Super IO Chipset Enable or disable High Definition Audio HD Audio Controller [Enabled] Controller. Onboard PCIEX GbE LAN [Enabled] LAN Option ROM [Disabled] Serial Port1 Address [3F8/IRQ4] Parallel Port Address [378] Parallel Port Mode [ECP] ECP Mode DMA Channel [DMA3] Parallel Port IRQ [IRQ7]...
Page 84
Advanced PCI/PnP Settings NO: Lets the BIOS configue all the WARNING: Setting wrong values in below sections devices in the system. may cause system to malfunction. YES: Lets the Plug And Play O/S [No] operating system PCI Latency Timer [64] configure Plug and Allocate IRQ to PCI VGA [Yes]...
Page 86
Suspend Mode [Auto] Select the ACPI state Repost Video on S3 Resume [No] used for System ACPI 2.0 Support [No] Suspend. ACPI APIC Support [Enabled] APM Configuration Hardware Monitor 4-30...
Page 87
APM Configuration Go into On/Off or Suspend when Power Power Button Mode [On/Off] button is pressed. Restore on AC Power Loss [Power Off] Power On By RTC Alarm [Disabled] Power On By External Modems [Disabled] Power On By PCI Devices [Disabled] Power On By PCIE Devices [Disabled]...
Page 89
Hardware Monitor AI Quiet [Disabled] CPU Temperature [32.5ºC/90.5ºF] MB Temperature [36.0ºC/96.5ºF] CPU Fan Speed (RPM) [3813RPM] Chassis Fan1 Speed (RPM) [N/A] Chassis Fan2 Speed (RPM) [N/A] Power Fan Speed (RPM) [N/A] VCORE Voltage [ 1.320V] 3.3V Voltage [ 3.345V] 5V Voltage [ 5.094V] 12V Voltage [11.880V]...
Page 91
Enter Go to Sub-screen General Help Save and Exit Exit Boot Device Priority 1st Boot Device [1st FLOPPY DRIVE] 2nd Boot Device [PM-ST330620A] 3rd Boot Device [PS-ASUS CD-S360] Select Screen Select Item Enter Go to Sub-screen General Help Save and Exit Exit 4-35...
Page 92
Boot Settings Configuration Allows BIOS to skip certain tests while Quick Boot [Enabled] booting. This will Full Screen Logo [Enabled] decrease the time AddOn ROM Display Mode [Force BIOS] needed to boot the Bootup Num-Lock [On] system. PS/2 Mouse Support [Auto] Wait For ‘F1’...
Page 93
<Enter> to change Security Settings password. Supervisor Password : Not Installed <Enter> again to User Password : Not Installed disabled password. Change Supervisor Password Select Screen Select Item Change Option General Help Save and Exit Exit 4-37...
Page 94
Security Settings Supervisor Password : Not Installed User Password : Not Installed Change Supervisor Password User Access Level [Full Access] Change User Password Clear User Password Password Check [Setup] Select Screen Select Item Change Option General Help Save and Exit Exit 4-38...
Page 96
Exit Options Exit system setup after saving the Exit & Save Changes changes. Exit & Discard Changes Discard Changes F10 key can be used for this operation. Load Setup Defaults Select Screen Select Item Enter Go to Sub-screen General Help Save and Exit Exit 4-40...
Need help?
Do you have a question about the P5PL2 and is the answer not in the manual?
Questions and answers