HP D5970A - NetServer - LCII Service & Reference Manual page 16

( c ) Terminator board must be installed when there is only 1 processor board in the system.
( d ) Early machines use several small single-slot panels.
( e ) This fan jumper must be installed on the system board.
( f ) Replace all A rev 64MB SIMMs with B rev parts.
( g ) This part number is constantly revised for each new release. When you order using this number you will
be sent the current revision of the CD-ROM.
( h ) Price list points from this part number to current part number.
( I ) Must install B1 plug on system board if any B1 CPUs in system.
Abbreviation
166-512
200-512
150-ohm
90-
Common Tray
DAC
Dove
FDD
Flint
HDD
I2C
P6
PCA
SIMM
10
Description
166MHz with 512K cache
200MHz with 512K cache
Older SCSI cable impedance
Ohm New SCSI cable impedance
An HP-standard drive mounting tray
Disk Array Controller
A color
Flexible Disk Dive
A color in the new color scheme
Hard Disk Drive
"I squared C" management bus
Pentium Pro chip
Printed Circuit Assembly
Single In-line Memory Module