Configuration; Overview; Step C. Verify Hardware Setup; Step D. Enable Integrated Hp Netraid Controller - HP D5970A - NetServer - LCII Configuration Manual

5 Configuration

Overview

This chapter covers Steps C, D, E, F, and G of the installation procedure. You
should already have completed Step A, "Plan Your Hardware," and Step B, "Plan
Arrays and Logical Drives" in Chapter 4.

Step C. Verify Hardware Setup

Verify that your hardware setup matches the plans you sketched in Worksheet A.
Make sure that:
Disk drive modules are inserted in the hot-swap mass storage cage
You have installed a second mass storage cage, or you have connected an
external mass storage enclosure, if you are planning to use two channels
SCSI IDs are set
NOTE Make sure the SCSI IDs of the non-hot-swap devices do not
conflict with the SCSI IDs of the hot-swap disk drive modules
connected to SCSI B.

Step D. Enable Integrated HP NetRAID Controller

The HP NetServer LH 3 and LH 3r factory default setting enables the integrated
HP NetRAID controller for the SCSI A port only. Use the Setup utility to verify
this setting, or to enable the integrated HP NetRAID controller for the SCSI B
port as well.
39