HP Xw4600 - Workstation - 2 GB RAM Installation Manual page 4

4. If your optical drive requires guide screws, use the four M3 guide screws provided as part of the
installation kit. Install two M3 guide screws into each side of the drive using a T-15 Torx screwdriver.
NOTE:
Workstations do not require guide screws.
5. Install the optical drive.
a. On some workstation models, you will need to lift the spring-loaded latch on the left side of
the optical drive cage
b. Slide the optical drive completely into a drive bay so that the drive is secured
CAUTION:
to the drive when moving the workstation. For specific instructions on securing an optional drive,
see the service guide for your workstation at http://www.hp.com/support/workstation_manuals.
6. Connect the cables.
CAUTION:
damage to the drive due to Electrostatic Discharge (ESD).
a. Connect the workstation optical power supply power cable
b. Connect the SATA interface cable
connector on the workstation system board.
NOTE:
NOTE:
workstation. Choose a cable with two straight connectors if possible. If you are using an
interface cable with a right angle connector, avoid interference with plug-in cards by attaching
the straight connector into the system board and the right angle connector into the device.
4 SATA optical drive installation
Some workstations, such as HP
while sliding the new drive in place.
Failure to ensure that the optical drive has been properly secured may cause damage
Connect the power cable before connecting the data cable to reduce the risk of
To locate system board connectors, see the service label on the side access panel.
Select an interface cable from the kit that best fits the configuration of your HP
600, 800, xw6600, xw8600, and xw9400
between the drive and the next available SATA
2
.
2
to the drive.
ENWW