HP Xw4550 - Workstation - 2 GB RAM Installation Manual page 3

Step 1—Preparing the workstation
Your workstation documentation includes instructions for preparing the workstation for installation.
To prepare the workstation for component installation:
1. Power down the workstation.
2. Disconnect power from the workstation.
For product-specific information, see the Service and Technical Reference Guide for your HP
workstation at http://www.hp.com/support/workstation_manuals.
Step 2—Attaching the rack mount tray to the workstation
1. Using a T-15 Torx driver, remove the two middle chassis screws (1) from the rear of the workstation
and set them aside for reuse.
Figure 1
2. Place the workstation (1) in the tray (2).
3. Guide the front bezel of the workstation (3) forward, under the lip of the tray (4).
4. Lower the workstation onto the tray.
Figure 2
ENWW
Removing the chassis screws
Placing the workstation onto the tray
Step 1—Preparing the workstation 3