Power Supply - HP Visualize J5000 - Workstation Manual

Visualize j class unix workstations

Hide thumbs Also See for Visualize J5000 - Workstation:

Table of Contents

Power Supply

This section describes how to remove and replace the Power Supply.

NOTE

Prior to removing the Power Supply, the Top, Front, and Side Panels need to

be removed. Refer to the appropriate section(s) for the steps to remove and

replace these components.

1. Facing the power supply, remove the PCI retainer clip by pressing down on the top of

the clip and pulling it out (see Step 1 below).

Figure 2-8. Removing the Power Supply, Steps 1–3

Step 1: Remove PCI Retainer Clip

2. Remove the bus bar shield by pulling outward on its latch, and then lifting it up (Step 2

above). This shield can be used to hold the screws you will remove in the next step.

3. Remove the four T-15 Torx thumbscrews (ﬁve screws if it's a J7000) from the power

supply bus bars (Step 3 above). The bus bar screws are longer than the other T-15 Torx

screws.

Chapter 2

Step 2: Remove Busbar Shield

Parts Removal and Replacement

Power Supply

Step 3: Remove Busbar Screws

Table of Contents

Do you have a question about the Visualize J5000 - Workstation and is the answer not in the manual?

Visualize j7000