3.
Pull down the ejector lever (2).
4.
Remove the blade PC from the enclosure.
To install a new blade PC, reverse the removal procedures.
Replacing the Memory
1.
Power down the blade PC
2.
Remove the blade PC from the enclosure
3.
Release the latches on each side of the DIMM slot (1). This allows the module to rotate upward.
4.
Remove the DIMM from the slot (2).
NOTE:
To replace the module:
1.
Insert the DIMM at a 15 degree angle (1), making sure that the notch on the bottom of the DIMM
aligns with the notch in the socket.
(Powering Down the BladeSystem PC on page
bc2800 shown
(Removing a Blade PC on page
Removal and Replacement
3).
4).
5