READ FIRST! Important Safety Precautions! of rubber or plastics may, in seldom cases, react chemically and discolor treated or non-treated wooden sur- faces if positioned without protection. 15. Warranty: The following conditions may result in a void prod- uct warranty: a.
Page 3
antenna discharge unit, size of 22. Power Sources. This product 28. Damage Requiring Service. Do grounding conductors, location of should be operated only from the type not attempt to service this product antenna-discharge unit, connection of power source indicated on the yourself, as opening or removing cov- to grounding electrodes, and require- marking label.
THANK YOU FOR CHOOSING JBL For more than 55 years, JBL ment that you expected – posted on our latest advance- has been involved in every and that when you think ments, and helps us to better aspect of music and film...
SPEAKER PLACEMENT FRONT CENTER CHANNEL SUBWOOFER SPEAKERS SPEAKER 0-0.6m (0-2 ft) SURROUND SPEAKERS † 1.5 – 1.8m 5 – 6 ft † Alternate placement for surround speakers in SCS260.5 † Surround back speaker is used system only. only in SCS260.6 system. The front speakers should be higher than the listeners’...
MOUNTING OPTIONS SATELLITES AND SURROUNDS On shelves. On the wall. On optional stands. Wall brackets are included. ATTACHING THE SHELF STAND TO THE SPEAKER Prepare the speaker wire as the left, and the negative gently on the wire to make described on page 8.
(not and proper use of the three parts. • supplied) . Make sure that bracket. JBL disclaims any liability for the selection of mounting hardware and/or bracket installation. Be sure to follow these bracket assembly and installation instructions carefully.
JBL, use red to are using the product in an plastic cap for the desired denote the (+) terminal and area covered by the Euro- terminal, insert the bare end black to denote the (–)
DOLBY* DIGITAL OR DTS ® (OR OTHER DIGITAL SURROUND MODE) CONNECTION output or subwoofer output and SCS260.6 systems, the RECEIVER SUBWOOFER on your receiver or amplifier. front left, front right, center Connect each speaker to the and rear speakers should all LINE LFE OUT LEVEL...
DOLBY PRO LOGIC (NON-DIGITAL) – SPEAKER LEVEL Use this installation method Left Front Right Front Center for Dolby Pro Logic applica- tions (not Dolby Digital, DTS – – – or other digital processing), where the receiver/proces- sor does not have a sub- woofer output, or a volume- controlled preamp (line-) level output:...
OPERATION Move the Master Power å switch (marked “Power” to the “•” (On) position to use the SUB260 subwoofer. ∫ If you will be away from home for an extended period of time, or if the subwoofer will not be used, switch the å...
Make sure possible, visit used, check the minimum none of the speaker wires www.jbl.com. impedance requirements of are frayed, cut or punc- your receiver/amplifier. tured, or touching each If there is no sound from the other.
Page 13
If there is no sound from • In Dolby Digital or DTS the surround speakers: modes, make sure your receiver/processor is con- • Check all wires and con- figured so that the surround nections between receiver/ speakers are enabled. amplifier and speakers. When all five satellites are Make sure all wires are in use, remember to config-...
Need help?
Do you have a question about the SCS 260.5 and is the answer not in the manual?
Questions and answers