Advertisement
Horizontal Installation
1
Attach the bottom plate to the bottom of the speaker
using the included M5x16 screws, as shown in the figure
below.
The bottom plate for DXR10 features a different shape
than the one shown in the figure.
x
M5
16
2
Assemble two L-shaped brackets into a U-shape using
the included M5x10 screws as shown in the figure below.
Peel off the sheet from each rubber spacer, and then
attach the spacers to the inside of each bracket arm by
aligning the holes so that the hexagon bolts can be
inserted.
M5
3
Make sure that the width of the U bracket matches the
speaker width.
4
Affix the U bracket on the wall or ceiling using
appropriate metal brackets and bolts. There will be a
slight gap between the U bracket and the wall surface.
Insert spacers into the gap and affix them with bolts.
These metal brackets or bolts are not included in the
package. If you are not sure what to use to affix the U
bracket, consult a specialist.
Bottom plate for
DXR10
x
M5
10
x
10
5
Use the included M8x25 hexagon bolts, spring washers,
and flat washers to attach the speaker to the U bracket.
UB-DXR15 / UB-DXR12
Use the bolt hole on the top of the speaker.
Hexagon bolt
UB-DXR10 / UB-DXR8
Use the bolt hole in the center of the handle on the top of
the speaker.
Hexagon bolt
Top
6
Adjust the speaker angle, then tighten the bolts until the
speaker is securely affixed.
Hexagon bolt
Hexagon bolt
3
Advertisement
