Client Mode Configuration - NETGEAR WG602 - 54 Mbps Wireless Access Point Reference Manual

Client Mode Configuration

In Client Mode, the WG602 will operate as a Client bridge only and send traffic to the remote AP
(Infrastructure Mode) or peer device (Ad-Hoc mode):
• Infrastructures – In this mode, the WG602v3 operates as a wireless client bridge that can
only connect and send traffic to an access point.
• Ad-Hoc – In this mode, the WG602v3 communicates on a peer-to-peer basis. There is no
structure of fixed points in the network.
The default mode for the WG602v3 is Infrastructure. However, no matter which mode is selected,
you must reconfigure the device after reboot. Once Client Mode is enabled, all of the existing
wireless access point settings are erased.
To enable and configure Client Mode:
1. Using your Web browser, log in to the WG602v3 using your selected method of login.
Figure 4-7
2. Under Advanced on the main menu, click Wireless Bridging. The Wireless Bridging screen
will display.
Advanced Configuration
NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual
v1.0, August 2006
4-9