Edelbrock 8135 Installation Instructions

PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with
common tools and procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not
feel comfortable performing this installation, it is recommended to have the installation completed by a qualified mechanic.
If you have any questions, please call our Technical Hotline at: 1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard
Time, Monday through Friday.
IMPORTANT NOTE: Proper installation is the responsibility of the installer. Improper installation
will void your warranty and may result in poor performance and engine or vehicle damage.
DESCRIPTION: The Universal Fuel Line and Filter Kit is designed to supply fuel to Edelbrock Performer and Thunder Series
carburetors from the existing 5/16" or 3/8" OEM steel fuel line. A high-capacity fuel filter is also incorporated into the fuel
line kit to ensure that clean fuel is supplied to the carburetor.

KIT CONTENTS:

1 Fuel Filter
1 Special Brass Adapter Fitting; 3/8" Hose to
5/16" OEM Fuel Line
1 Special Brass Adapter Fitting; 3/8" Hose to 3/8"
OEM Fuel Line
NOTE: Installation is usually done at the same time as the new carburetor is installed. Therefore, these instructions should
be incorporated into your carburetor installation at the appropriate time, such as after mounting the carburetor to the intake
manifold, and connecting the throttle and kick-down linkages. Refer to Figure 1 below for reference during this
installation.
Catalog #8135
Rev.A - 1/12 - CP

INSTALLATION PROCEDURE

Figure 1 - Fuel Filter Assembly Diagram
1
UNIVERSAL FUEL LINE AND FILTER KIT
For 5/16" and 3/8" OEM Fuel Tubing
INSTALLATION INSTRUCTIONS
1 5/16" Compression Nut with Sleeve
1 3/8" Compression Nut with Sleeve
1 3/8" Fuel Hose; 24" Length
4 Hose Clamps
Catalog #8135
©2012 Edelbrock LLC
Brochure #63-8135