System Requirements; Setting Up The Device Driver; Installing The Cd-Rom Drive; Manual Setup - Samsung SC-148S User Manual

System Requirements

Before you install the CD-ROM drive, we strongly recommend that you make certain
that your set-up meets the system requirements listed below.
Item
Type of computer
Free expansion unit
Disk space
MS-DOS version
Windows version

Installing the CD-ROM Drive

Install the CD-ROM drive in your computer horizontally, making sure that the Open/Close
button is on the right.
To install the drive, proceed as follows.
1 Turn OFF your computer. Remember to verify the
configuration jumper on the rear of the CD-ROM drive.
2
Remove the cover of your PC(main unit of the computer)
3
Remove the blank cover panel of the 5.25 inch unit in
which the CD-ROM drive is to be installed.
4
Connect the CD-ROM drive to the IDE interface and power
cables Iocated inside your computer.
Connectors are keyed so it is impossible to put them in
an incorrect position. Do not force the connectors, if they
do not seem to fit.
5 Install the CD-ROM drive into the unit and secure it with
mounting screws (recommended standard M3x6x4)
Depending on your PC model, you may need to
attach guide rails to the drive, so that the drive is
held firmly in place.
If you use screws that are longer than the
recommended standard, you may damage the
drive.
6
Put the cover back on your PC.
Description
IBM 486SX 20MHz (or higher) with
an IDE interface(or a 100% IBM-
compatible computer)
5.25 inch
100KB minimum
5.0(or higher)
3.1(or higher)
4

Setting Up the Device Driver

It is not necessary to set up additional device driver for Window
95/98/2000/NT because it uses the device driver provided by the Window.
Automatic Setup
1
Insert the setup diskette in the diskette drive and change the directory to A:,
where A: is the diskette drive.
To do so, type A: after the C:\ prompt and press [Enter].
2
Type CDSETUP and press [Enter].
3
Reboot the computer.

Manual Setup

1
Make the C:\SAMSUNG directory.
2
Copy the files from the diskette to the C:\SAMSUNG directory.
* . *
To do so, type COPY A: C:\SAMSUNG after the C:\ prompt and press
[Enter].
3
Edit the CONFIG.SYS file.
Add the DEVICE=C:\SAMSUNG\SSCDROM.SYS \D:SSCD000 /V entry.
LAST DRIVE = Z
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
DEVICE = C :\SAMSUNG\SSCDROM.SYS /D : SSCD000 /V
4
Edit the AUTOEXEC.BAT file.
Add the C:\SAMSUNG\MSCDEX /D:SSCD000 entry.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
C :\SAMSUNG\MSCDEX /D:SSCD000
5
Reboot the computer.
5