Advertisement
3. SCSI ID Setup Switch for Channel A
(SCSI ID, chA)
The SCSI-ID for Channel A is set with this switch.
Refer to page 8 for ID Number Setting.
4. SCSI ID Setup Switch for Channel B
(SCSI ID, chB)
The SCSI-ID for Channel B is set with this switch.
5. Fans
These Fans prevent temperature rise inside the unit.
Note: The fans are wear items and need to be
replaced periodically.
Operating Time
8 hours daily
12 hours daily
24 hours daily
~
6. AC Inlet (
AC IN)
Connect the provided power cord to this Inlet.
INITIAL SETTING
Warning
Before connecting an HDD, pull out the power plug
from the electrical outlet for safety. Failure to do so
may cause electric shock.
Cautions
• Before starting work, carefully read the Operating
Instruction Manual attached to the HDD.
• Before handling HDDs, touch the metal case of
the HDD box to discharge static from the body.
For added safety, wear an antistatic wrist strap.
• Keep unused HDDs on an antistatic mat. Keep
the metal parts of HDDs out of contact with the
metal parts of other HDDs.
3
Operating Life
6 years
4 years
2 years
7. SCSI Output Connector for Channel B (chB/OUT)
Connect the "chB/IN" terminal of an additional HDD-
BOX to this connector.
8. SCSI Input Connector for Channel B (chB/IN)
Connect the "chB/OUT" terminal of an additional
HDD-BOX to this connector.
Used for connection with the channel B SCSI con-
nector of the SCSI board.
9. SCSI Output Connector for Channel A (chA/OUT)
Connect the "chA/IN" terminal of an additional HDD-
BOX to this connector.
10. SCSI Input Connector for Channel A (chA/IN)
Connect the "chA/OUT" terminal of an additional
HDD-BOX to this connector.
Used for connection with the channel A SCSI con-
nector of the SCSI board.
Set the jumper pins before installing HDDs.
Remove all jumper pins originally set at the factory as
indicated below.
Term. Power to SCSI Bus
J6
Pin 1
J2
R
T D M W P E T T
E S E P D S P P
Install this jumper
pin only.
J2
J1
WIDE SCSI I/O
Connector
DC Power
Connector
Advertisement
