Preparing For Surround Sound; Speaker Settings - Kenwood KRF-V5050D Instruction Manual

Preparing for surround sound

Speaker settings

18
To enable you to obtain optimum enjoyment from the receiver's listening
modes, make sure to complete the speaker settings (subwoofer, front,
center, and surround speakers) as described below.
MULTI CONTROL
POWER
ON/STANDBY
RC-R0616
1
Turn on the power to this receiver by pressing POWER or
ON/STANDBY key.
2
Select a speaker system.
1 Press the SET UP key such that the subwoofer setting
indication (SUBW ON) appears.
SP A B TI.VOL
L C R
CLIP MUTE
LFE SW
RDS EON PTY
LS S RS
TP TA NEWS
2 Use the MULTI CONTROL keys to select the appropriate
subwoofer setting.
1 SUBW ON: Subwoofer setting mode to the receiver is ON.
2 SUBW OFF: Subwoofer setting mode to the receiver is OFF.
• The initial setting is "SUBW ON".
• When "SUBW OFF" is selected, the front speakers are automatically
set to "FRNT LRG" and the procedure skips to step 5.
• When subwoofer output sound is required, select "FRNT NML".
3 Press the SET UP key again to accept the setting.
• The front speakers setting indication (FRNT) appears.
SP A B TI.VOL
L C R
CLIP MUTE
LFE SW
RDS EON PTY
LS S RS
TP TA NEWS
4 Use the MULTI CONTROL keys to select the appropriate front
speakers setting.
1 FRNT NML (normal): Average size front speakers are
2 FRNT LRG (large):
• For "FRNT LRG" selection, no sound will be heard from SUBW
even when it is set to ON. However, if you select CINEMA EQ.
when subwoofer is selected, you will be able to hear sound from
the subwoofer.
When in STEREO mode, the sound goes directly to front speaker.
5 Press the SET UP key again to accept the setting.
• The center speaker setting indication (CNTR) appears.
SET UP
SET UP
MULTI
CONTROL
RC-R0512
FM AUTO SOUND
AM PRO LOGIC
MHz 3 STEREO
kHz DOWN MIX
FM AUTO SOUND
AM PRO LOGIC
MHz 3 STEREO
kHz DOWN MIX
connected to the receiver.
Large front speakers are con-
nected to the receiver.
6 Use the MULTI CONTROL keys to select the appropriate center
speaker setting.
If you have selected "LRG" as the front speakers setting,
1 CNTR LRG (large):
2 CNTR NML (normal): An average size center speaker is con-
3 CNTR OFF:
If you have selected "NML" as the front speakers setting,
1 CNTR ON:
2 CNTR OFF: Center speaker setting mode to the receiver
7 Press the SET UP key again to accept the setting.
• The surround speaker setting indication (SURR) appears.
8 Use the MULTI CONTROL keys to select the appropriate
surround speaker setting.
If you have selected "LRG" as the center speaker setting,
1 SURR LRG (large):
2 SURR NML (normal): Average size surround speakers are
3 SURR OFF:
If you have selected other than "LRG" as the center speaker
setting,
1 SURR ON:
2 SURR OFF: Surround speaker setting mode to the
9 Press the SET UP key again to accept the setting.
DIGITAL AUTO
• The receiver enters the speaker volume level adjustment mode.
S.DIRECT MEMO
ST.
MONITOR • In steps 3 and 4, indications appear only for the selected channels
TUNED
DSP
of the speakers that require adjusting.
3
Adjust the speaker volume.
From your usual listening position, adjust the volume levels. The
volume levels from each speaker should be the same.
1 Use the MULTI CONTROL keys to adjust the volume of the
test tone output from the speaker channel to be adjusted.
The channel indication blinks while the test tone is being output.
SP A B TI.VOL
CLIP MUTE
RDS EON
DIGITAL AUTO
TP TA NEWS
S.DIRECT MEMO
MONITOR ST.
TUNED
DSP
The test tone is heard from the speakers for 2 seconds at
a time in the following sequence for 2 seconds each:
• If you change the volume level settings for the speakers while
listening to music, the settings referred to on this page are also
changed.
• If the speaker setting selects are changed, the speaker level
settings are reset.
2 Press the SET UP key.
• The test tone is turned off. The receiver enters the mode for
inputting the distance to the speakers.
A large center speaker is connected to
the receiver.
nected to the receiver.
Center speaker setting mode to the
receiver is OFF.
Center speaker setting mode to the receiver
is ON.
is OFF.
Large surround speakers are con-
nected to the receiver.
connected to the receiver.
Surround speaker setting mode to the
receiver is OFF.
Surround speaker setting mode to the
receiver is ON.
receiver is OFF.
L C R
LFE
PTY
LS S RS
L = C = R = SR = SL = SW
FM AUTO SOUND DIGITAL AUTO
AM PRO LOGIC S.DIRECT MEMO
MHz 3 STEREO MONITOR ST.
TUNED
kHz DOWN MIX DSP
º