Volume; Attenuator; Audio Control Setting - Kenwood DPX-7010MD Instruction Manual

switching adapter (KCA-S210A or CA-C1AX) or CD changer
(KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is
connected to this unit.
During the AUX mode, "Aux Mode" will show in the display.
When the CA-C1AX is being used, the AUX Mode will replace
the External Disc Control Mode.

Volume

Increasing Volume:
Press the 5 button to turn up the volume.
Decreasing Volume:
Press the ∞ button to turn down the volume.

Attenuator

This function allows you to turn down the volume quickly.
Turning Attenuator On/Off:
Press the ATT button to switch the attenuator on and off.
When the attenuator is on, the ATT indicator blinks.
When the attenuator is off, the volume returns to the original
level.
NOTE
Turning the volume up, or turning it all the way down deactivates
the attenuator function.

Audio Control Setting

Adjust various parameters of sound quality.
1
Press the AUD button for at least one second to enter the
control mode.
2
Selecting mode
Press either the 4/¢ button.
Each time the button is pressed, the adjustment mode will
change.
Please refer to the following for the contents of the
adjustment modes.
3
Adjust each mode
Press the FM or AM button.
Please refer to the following for the adjusting values.
4
Press the AUD button to end the control mode.
"Balance" : Adjust the balance level.
Setting values: Left 15 – Right 15
"Fader" : Adjust the fader level.
Setting values: Front 15 – Rear 15
"N-F" : Adjust the Non-fading output level.
Setting values: – – – – + 10
NOTE
This mode is available only when the non-fading output function
is set to on.(P.23)
"Amp Cont" : Adjust the bass boost level of the external
amplifier using the main unit.
"Off" : Bass boost level is flat.
"1" : Bass boost level is low (+6dB).
"2" : Bass boost level is high (+12dB).
NOTE
As of December 1998, the power amplifiers controllable by the
main unit are as follows:
KAC-X501F/PS501F/X401M/PS401M/X301T/PS301T/X201T/PS201T
— 7 —