Dell PowerEdge M420 Administrator's Manual page 78

B
supportShow
iscsi
fcip
ag
dce_hsl
crypto
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to
Admin Domain restrictions"
This is a diagnostic command and should only be run for diagnostic support.
Output generated by this command may vary by switch configuration and platform. Output may
change without notice.
Operands This command has the following operands:
slotnumber
portnumber1-portnumber2
lines
Examples To display debugging information:
64
iSCSI group commands, disabled by default.
FCIP group commands, disabled by default.
Access Gateway group commands, disabled by default.
DCE group commands, enabled by default.
Encryption group commands, disabled by default.
"Understanding Virtual Fabric restrictions"
on page 33 for details.
On bladed systems only, specifies a slot number, followed by a slash (/).
Specifies the range of ports for which to display supportShow information. If a
port range is not specified, the command displays information for all ports.
Specifies the number of lines for the portLogDump output. This parameter is
valid only with the slotnumber/portnumber parameters.
switch:admin> supportshow
VF
======================
Date:
Wed Oct 22 09:31:41 UTC 2008
Time Zone:
Time Zone Hour Offset: 0
Time Zone Minute Offset: 0
Version:
Kernel: 2.6.14.2
Fabric OS: v6.2.0_main_bld26
Made on: Mon Oct 20 10:10:30 2008
Flash: Mon Oct 20 16:04:18 2008
BootProm: 1.0.6
supportshow groups enabled:
os enabled
exception enabled
port enabled
fabric enabled
services enabled
security enabled
network enabled
portlog enabled
system enabled
extend disabled
filter disabled
on page 32 and
Dell 8/4Gbps FC SAN Module Administrator's Guide
"Understanding
53-1001345-01