Communication Setup; Communication Port - Hitachi CP-WX1100 Network Manual

3.7.2 Communication setup

1) Using the SERIAL OUT SETTING menu, select the proper baud rate and
parity for the CONTROL OUT
232C port of the connected device. (
- SERVICE – COMMUNICATION – SERIAL IN SETTING/SERIAL OUT
SETTING)
BAUD RATE
Data length
2 ) Using the COMMUNICATION TYPE menu, select the NETWORK BRIDGE
for the CONTROL OUT CONTROL OUT port. (
SERVICE – COMMUNICATION – COMMUNICATION TYPE)
3) Using the COMMNICATION METHOD menu set up the proper method for the
CONTROL OUT port, according to your use. ( CONTROL OUT
menu - SERVICE – COMMUNICATION – COMMUNICATION METHOD)
NOTE
• The OFF is selected for the COMMUNICATION TYPE as the default
setting.
• Using the COMMUNICATION menu, set up the communication. Remember
that an unsuitable setup could cause malfunction of communication.

3.7.3 Communication port

For the NETWORK BRIDGE function, send the data from the computer to the
projector with using the Network Bridge Port that is confi gured in the "Port
Settings" of web browser. (
NOTE
• Any number between 1024 and 65535 can be set up as the Network
Bridge port number. It is set to 9717 as the default setting.
CONTROL OUT port, according to the specifi cation of the RS-
Item
4800bps/9600bps/19200bps/38400bps
PARITY NONE/ODD/EVEN
8 bit (fi xed)
Start bit 1 bit (fi xed)
Stop bit 1 bit (fi xed)
3.1.4 Port settings – Network Bridge Port)
3. Management with Web browser software
Operating Guide - OPTION menu
Condition
Operating Guide - OPTION menu -
Operating Guide - OPTION
47