Using The Appliance For The First Time; Switching On And Preheating - Whirlpool ACE 102 IX Instructions For Use Manual

USING THE APPLIANCE FOR THE FIRST TIME

• Coffee has been used to factory test the machine and it is therefore completely normal for there to be traces of coffee in
the mill.
• Customize water hardness as soon as possible, following the instructions in paragraph
1. Connect the appliance to the mains power supply. Set the desired language.
2. Scroll using the buttons
instructions in paragraph
displayed. English is the reference language for the instructions. Next, follow the instructions indicated on the display.
3. After 5 seconds, the display shows
water then replace in the machine.
4. Place a cup underneath the hot water spout (Figure 5). (If the water spout is not inserted, the appliance displays the
message
(Figure 3) and after a few seconds, water runs out of the spout.
5. The display shows
6. Slide the machine out, using the handles provided (Figure 7); open the lid, fill the coffee bean container, then close the lid
and push the machine back into the housing.
The coffee machine is now ready for normal use.
WARNING
N.B.:
• When using the appliance for the first time, you need to make 4/5 cups of coffee and 4/5cappuccinos before the
appliance gives good results.
• Each time the machine is turned on using the main ON/OFF switch (A23) it runs the SELF-DIAGNOSIS function and then
switches off: to switch back on again, press the (A7) on/stand-by button (Figure 1).

SWITCHING ON AND PREHEATING

Each time the machine is switched on, it performs an automatic preheat and rinse cycle which cannot be interrupted. The
machine is ready for use only after completion of this cycle
WARNING
To switch the appliance on, press the (A7) on/stand-by button (Figure 1): the display shows
heating, the display shows another message:
(B5 and B6) until you find the desired language (Figure 2). When the display shows:
, press the OK button (B7) (Figure 3). If you select the wrong language, follow the
. If, on the other hand, your language is not available, select one of those
: remove the water tank (Figure 4), rinse and fill to the MAX line with fresh
: insert it as shown in Figure 6. The display shows
and switches off.
Never place pre-ground coffee, freeze-dried coffee, caramelized coffee or foreign objects
in the container, as they could damage the machine
Risk of burns! During rinsing, some hot water is run off from the coffee spouts.
. The machine is at working temperature when the display shows
.
GB30
.
. Press OK (B7)
. After