Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 263
Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message PLATFORM-2-PS_UNSUPPORTED: Detected an unsupported power supply [dec]
[chars] for CISCO MDS 9500/9200 Multilayer Switches (Serial number [chars]).
Error Message PLATFORM-2-SYS_IDPROMBAD:
Error Message PLATFORM-2-SYS_IDPROMBAD_RECOVER_FAIL: Chassis IDPROM [dec] data
re-initialization Un-successful. Data is invalid.
Error Message
re-initialized successfully.
PLATFORM-3
Error Message
[chars]).
OL-15956-01
This power supply is not supported for the Cisco MDS 9500 or 9200 series of switches.
Explanation
Refer to the appropriate product hardware installation guide for information
Recommended Action
on increasing or decreasing power supply capacity and configuring power supplies.
Introduced
Cisco MDS SAN-OS Release 1.2(2a).
The named chassis IDPROM contains invalid data.
Explanation
Use the show sprom module [decimaldigit] CLI command to read module
Recommended Action
IDPROM contents and collect more information. Or, use a similar Fabric Manager procedure.
Introduced
Cisco MDS SAN-OS Release 3.0(1).
Chassis IDPROM re-initialization was unsuccessful. The data is invalid.
Explanation
Us ethe 'show sprom module decimal digit 1 CLI command to read the
Recommended Action
module IDPROM contents and collect more information.
Cisco MDS SAN-OS Release 3.0(2).
Introduced
PLATFORM-2-SYS_IDPROMBAD_RECOVER_PASS: Chassis IDPROM [dec] data
Explanation
Chassis IDPROM invalid data was succesfully re-initialized to valid.
Us ethe 'show sprom module decimal digit 1 CLI command to read the
Recommended Action
module IDPROM contents and verify the information.
Cisco MDS SAN-OS Release 3.0(2).
Introduced
PLATFORM-3-MOD_PWRFAIL: Module [dec] failed to power up (Serial No.
The module failed to power up.
Explanation
Enter the show platform internal all module [dec] CLI command or use a
Recommended Action
similar Fabric Manager/Device Manager procedure to collect more information.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Chassis IDPROM [dec] data invalid.
Cisco MDS 9000 Family System Messages Reference
2-227
Advertisement
Table of Contents
