Advertisement
Available languages
Available languages
NOTE: During this time the room humidity
level will continue
to be monitored
and
the humidifier
wil! cycle the fan on and off until the filter is completely
dry, The fan
will shut off leaving you with a dry humidifier
that is less prone to mold and mildew
growth.
If DRY OUT MODE
is not desired,
refill the humidifier
with water and the
fan will return to the set speed.
NOTE:
Fan automatically
switches
to lowest speed
during DRY OUT MODE
Check Filter indicator
The ability of any humidifier
to efficiently
supply
humidity
output relies heavily on the condition
of the filter. As the filter loads with impurities it
gradually
loses its wicking
capability.
When this
happens,
moisture
output is reduced
and the
humidifier
has to work longer to satisfy the
selected
setting. This humidifier
has a check
filter reminder
timed to appear
after 720 hours
of operation.
When display
shows
an
alternating
"CF" and "room humidity"
setting
at
5 second
intervals
it is a reminder
to check the
filter condition°
Ctl#{;k r,tlt{_r
Display
Humidistat
The humidistat
located on the power
cord senses the percentage
of
humidity
in the air. tt causes
the
humidifier
to cycle on and off to
maintain
the selected
humidity
SET
point° The fan will turn on if the
"ROOM"
reading
falls 3% below the
SET point and will continue
to run the
humidifier
until a reading
of 1% above
the SET point is achieved.
The fan
wilt turn off until the ROOM
reading
falls 3% below the SET point again.
NOTE: Be sure that the humidistat,
which is located on the power cord, is
free from obstruction and away from
any hot air source,
Control
Lock Out
To avoid unwanted tampering with the
humidifier settings the controls can be
locked,
Activation
Procedure
After the humidifier
functions
have been
set up, hold the power button down for
5 seconds° The display will show "CL"
for 2 seconds;
release
the power button
and the control will resume
the display
of the room humidity.
The room
humidifier
will continue
to function
with
the locked in settings,
If buttons
are
operated
while "CL"
is active, the "CL"
is displayed
and settings
are
unaffected,
Deactivation Procedure
To deactivate
the "CL"
function
simply
press and hold the power
button for 5
seconds.
"CL"
will flash at the rate of t
second
on and 1 second
off for a period
of 2 seconds
and then resume the
display
of room humidity.
Advertisement
