Running The Self Test - Epson TM U295 - B/W Dot-matrix Printer Operator's Manual

4. Insert the paper from either the front or the side, as shown in
the illustration below. Insert the paper into the printer until it is
stopped by the form stopper. The markings on the side of the
printer can also be used to judge how far to insert paper.
5. Check the PAPER OUT light. When you insert the paper
correctly, the PAPER OUT light goes out. If the PAPER OUT light
is still on, remove the paper and re-insert it.

Running the Self Test

Any time that you want to check the performance of your printer
you can run the self test described below. This shows whether your
printer is working correctly. It is independent of any other
equipment or software.
The self test checks the control circuits, printer mechanisms, print
quality, RAM, ROM version, and DIP switch settings.
To perform the self test, follow the steps below:
1. Insert a sheet of paper following the instructions on page 1-12.
2. Turn off the printer.
Installation 1-13