Adjusting The Printing Start Position - Epson C11C560111 - PLQ 20 B/W Dot-matrix Printer User Manual

Note:
The top-of-form position can be set from 1.0 mm to 33.8 mm in the
PR2 mode and from 1.0 mm to 33.9 mm in the ESC/P and IBM
PPDS modes.
6. Insert a sheet of A4 paper into the front slot. The printer prints
triple H in capitals (HHH) on the current top-of-form position
and ejects the sheet. You may continue to adjust the position
by pressing the F1/Eject and F2 buttons and checking the
position by inserting another sheet.
7. After finishing the adjustment, turn off the printer. The setting
does not change even if the printer is turned off.

Adjusting the printing start position

The printing start position is the horizontal position on the page
where the printer starts printing. If the printout appears too for
the left or right on the page, you can use this function to adjust
the printing start position.
Follow these steps to adjust the printing start position:
Note:
Your printing start position setting remains in effect until you
change it, even if you turn off the printer.
22
Paper Handling