Table of Contents
Advertisement
3. Position each PCMCIA ribbon cable connector so that the
small tab in the middle of the connector aligns with the
middle notch of each connector socket.
4. Make sure the holes in the ribbon cable connector fit over all
the pins in the drive connector socket; then push in each
cable connector.
Caution
Make sure you correctly align the holes with the pins, or
you could severely damage the socket pins on the drive.
5. Mount the dual drive in the drive bay as described in your
computer manual, securing the drive with four screws as
shown below. Make sure the face of the dual drive is flush
with the front of the computer.
Note
Depending on the construction of your drive bay, you may
have to first pass the loose end of the PCMCIA ribbon cable
through the front of the drive bay before completely sliding
the drive into the bay.
9
Advertisement
Table of Contents
