Dymo Organizer Xpress Embossing Label Maker User Manual

User guide

Extend the embossing tape about

one inch. This will allow for easier

loading in the Organizer Xpress.

Insert the embossing tape into the

slot located at the top of the label

compartment. Feed the tape in as far

as you can. Place the embossing

tape in the label compartment.

Squeeze the handle two times to help

feed the tape through the unit.

Turn the wheel to select different

characters.

Organizer Xpress Guide

Grab ahold of the door located on

the handle of the Organizer Xpress

and pull to open

Close the label compartment door.

Squeeze the handle two more times

to continue feeding the tape through

Select the

the unit.

symbol.

Do you have a question about the DYMO Organizer Xpress Embossing Label Maker and is the answer not in the manual?

Page 1: Organizer Xpress Guide
Organizer Xpress Guide Extend the embossing tape about Grab ahold of the door located on one inch. This will allow for easier the handle of the Organizer Xpress loading in the Organizer Xpress. and pull to open Insert the embossing tape into the Close the label compartment door.
Page 2 Firmly squeeze the handle. Normally Turn the wheel and select the symbol. will cut the tape, however while loading a new roll of tape you can select this symbol to help feed the tape through the unit. Turn the wheel to the desired Firmly squeeze the handle twice to character.
Page 3 Firmly squeeze the handle to Select the symbol. advance the tape without embossing any characters. Firmly squeeze the handle to cut the Remove the backing and apply the tape. tape to the desired surface.

Organizer xpress