Hitachi DS18DSAL - 18V 1/2" Driver Drill 460 In/Lbs Torque Instruction Manual page 15

When carrying the power tool with hooked to your
waist belt, do not fit any bit to the tip of power
tool. If the sharp bit such as drill is fitted to the
power tool when carrying it with hooked to your
waist belt, you will be injured.
Install securely the hook. Unless the hook is securely
installed, it may cause an injury while using.
(1) Removing the hook.
Remove the screws fixing the hook with Philips
screw driver. (Fig. 10)
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fix the hook firmly.
(Fig. 11)
Hook
Work
Wood
Drilling Steel
Aluminum
Small
screw
Screw
Wood
tightening
screw
Screw
Hook
Fig. 10
Screw
Fig. 11
Clutch dial position
1 – 22
1 –
11. Using the light
Pull the trigger switch to light up the light. The light
keeps on lighting while the trigger switch is being
pulled. The light goes out after releasing the trigger
switch. (Fig. 12)
Light
Trigger switch
CAUTION:
Do not look directly into the light. Such actions
could result in eye injury.
12. The scope and suggestions for uses
The usable scope for various types of work based
on the mechanical structure of this unit is shown
in Table 5.
Table 5
Use for drilling purpose.
Use the bit and socket matching the screw
diameter.
Use after drilling a pilot hole.
Fig. 12
Suggestions
English
15