GE GTUP240GMWW Installation Instructions Manual page 9

C
H
ELBOW HIGHLY
RECOMMENDED
C
H
DO NOT USE
EXCESSIVE
C
H
EXHAUST
LENGTH
C
H
9 DRYER EXHAUST TO RIGHT, LEFT
OR BOTTOM CABINET
WARNING -
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE APPLIANCE FROM
ITS ELECTRICAL SUPPLY. PROTECT
YOUR HANDS AND ARMS FROM SHARP
EDGES WHEN WORKING INSIDE THE
CABINET. BE SURE TO WEAR GLOVES
For downward venting, rotate elbow
sections so that elbow points downward
REMOVE
DESIRED
KNOCKOUT
(ONLY 1)
Installation Instructions
DO
C
H
C
H
DON'T
DO NOT SIT
APPLIANCE
ON FLEXIBLE
EXHAUST
DO NOT
CRUSH
FLEXIBLE
EXHAUST
AGAINST
WALL
BEFORE PERFORMING
C
H
EXHAUST TO LEFT OR RIGHT SIDE OF
CABINET
• For side ducting, remove the knockout (ONLY 1).
Rotate elbow sections so that the points to the side.
Preassemble 4" elbow with 4" duct. Use only 4" UL
approved rigid metal for ducting inside the dryer.
• Insert duct assembly through the side opening and
connect to the internal elbow.
CAUTION:
Be sure not to pull or damage the
electrical wires inside the dryer when inserting the
duct.
4" UL approved rigid metal
• Apply duct tape as shown on the joint between the dryer
internal duct and the straight duct pipe.
9
C
H
DUCT
C
H
TAPE
CAUTION:
Internal duct joints must be
secured with tape, otherwise
they may separate and cause
a safety hazard.