Satellite Configuration; Satfind - DREAM MULTIMEDIA DREAMBOX DM 500S User Manual

17.

Satellite Configuration

Press the MENU-Button to enter the OSD-Mainmenu.
Go to Setup -> Service Searching -> Satellite Configuration.
18.

Satfind

Press the MENU-Button to enter the OSD-Main menu.
Go to Setup -> Service Searching -> Satfind.
Navigate to the upper Dropdownlist and choose
your appropiate Satellite Configuration and press
the OK-Button. Choose your Satellites the Dish is
adjusted to and press the green Option-Button to
save configuration.
This Configuration might differ from yours.
Choose from the lower Dropdownlists your preferred
satellite and transponder.
Adjust the Dish towards the desired satellite until
you have a high value on the Signal strength AGC
and on the Signal quality SNR indicator. The BER
should always indicate a value of zero if the Satellite
is locked and synced.
SNR: Signal to Noise Ratio
This Indicator shows the Quality of the Signal.
AGC: Automatic Gain Control
This Indicator shows the Strengh of the Signal.
BER: Bit Error Rate
This Indicator shows the Errors Rate of the Signal.
- 18 -