Kenmore 8075 - 24 in. Laundry Center Use And Care Manual page 13

1=
2.
Loosen or remove center, silver-colored terminal block screw.
Place the hooked end of the neutral wire (white or center wire)
of direct wire cable under the center screw of terminal block
(hook facing right). Squeeze hooked end together. Tighten
screw.
C
L_
E D
A. Neutral wire (white or center wire)
B. Center sliver-colored terminal block screw
C. Neutral ground wire
D. Internal ground conductor screw
E. 3/4"(1.9 cm) UL listed, strain relief
Place the hooked ends of the other power supply cable wires
under the outer terminal block screws (hooks facing right).
Squeeze hooked ends together. Tighten screws.
4. Tighten strain relief screw.
5. Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down screw.
6. You have completed your electrical connection. Now go to
"Venting Requirements."
Optional 3-wire connection
Use for direct wire or power supply cord where local codes
do not permit connecting cabinet-ground conductor to
neutral wire.
1. Remove center, silver-colored terminal block screw.
2. Remove neutral ground wire from internal ground conductor
screw. Connect neutral ground wire and the neutral wire
(white or center wire) of power supply cord/cable under
center, silver-colored terminal block screw. Tighten screw.
i D
E
A. Neutral wire (white or center wire)
B. Neutral ground wire
C. External ground conductor screw
B L
C
D. Grounding path determined by a qualified electrician
E. Internal ground conductor location
Connect the other wires to outer terminal block screws.
Tighten screws.
4. Tighten strain relief screws.
5. Move the green painted screw from the internal to the
external ground conductor location. Connect a separate
copper ground wire from the external ground conductor
screw to an adequate ground.
6. Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down screw.
13