Yamaha MSP7Studio Owner's Manual page 12

SW10 STUDIO
SW10 STUDIO
1
1
POWER switch
Turns power to the speaker on or off. When the power is
turned on the POWER indicator (8) on the front panel will
light green.
2
AC IN Connector
Connect the supplied power cable here. First connect the
power cord to the subwoofer, then insert the power cord plug
into the AC outlet.
3
PHASE switch
Selects a phase of output sound from the SW10 STUDIO.
You will usually set this switch to "NORM". However, the "REV."
setting may improve low-range response, depending on the
type and location of the entire speaker system. Try both set-
tings and select the one that produces the best low-end
sound.
4
HIGH CUT control
Use the HIGH CUT control to set the cutoff frequency of the
signal output from the SW10 STUDIO from 40 Hz to 120 Hz.
12
MSP7 STUDIO/MSP5 STUDIO/SW10 STUDIO Owner's Manual
(Rear Panel)
3 4 5
2
(Front Panel)
6
7
5
LEVEL control
Adjusts the overall output level.
6
INPUT L/R/SUBWOOFER connector
These are balanced XLR-type input connectors. Three differ-
ent signals can be simultaneously input via these connectors.
The input signals are mixed before being sent to the sub-
woofer.
7
OUTPUT L/R/SUBWOOFER connector
These XLR-type balanced output connectors output the sig-
nals received at the INPUT L/R/SUBWOOFER connectors,
respectively.
8
POWER indicator
When the power is turned on the POWER indicator will light
green. The power indicator will flash red to indicate clipping.
8