Panasonic WV-CP504 Installation Manual page 19

n
Turn on the power.
WV-CP500
The included power cord is connected to this power connector.
Connect between the power connector on the rear side of the camera and a plug socket
with the supplied power cord.
120 V AC 60 Hz
WV-CP504
Important:
• The power supply of 24 V AC/12 V DC shall
be insulated against 120 V AC.
• The power supply is automatically selected
either 24 V AC or 12 V DC. No setting is
required with this camera.
q Loosen the screw of the power cord plug
(accessory).
w Connect the power supply (option) of 24 V
AC or 12 V DC to the power cord plug.
Strip the end of the wire by 3 mm to 7 mm
{1/8" to 1/4"}, and twist the stripped part of
the wire sufficiently to avoid short circuit.
• Specification of cable (wire)
AWG #16 - #28, Single core, twisted
* Check whether the stripped part of the
wire is not exposed and is securely con-
nected.
<Ratings>
AC 24 V
2-N
GND
1-L
e Tighten the screw of the power cord plug.
r Connect the power cord plug to the AC/DC
power terminal on the rear side of the camera.
* Make sure that the power cord plug is inserted fully into the AC/DC power supply terminal.
Power cord (accessory)
DC 12 V
@ (GND)
NC
!
ALARM OUT POWER
GND
ALARM IN
VIDEO OUT
120V ~ 60Hz
ALARM OUT GND
VIDEO OUT
POWER
ALARM IN
(UP)
NEAR BF/MENU FAR
~
24V IN
1-L 2-N
(LEFT) (SET) (RIGHT)
GND
(DOWN)
12V IN
NC
To 24 V AC/12 V DC
power supply
Power cord plug
(accessory)
Stripped
Approx. 3 mm - 7 mm
{1/8" to 1/4"}
19