Synchronization Setting [Sync]; Electronic Zoom Setting [Electric Zoom]; Image Freezing [Freeze]; Default Setting Restoring - Panasonic GPUS932CU - 3CCD COLOR CAMERA CCU Operating Instructions Manual

10. Synchronization setting [SYNC]

The synchronization state is displayed. The horizontal
phase in the external synchronization can also be adjusted.
The internal synchronization is indicated as "INT", and the
external synchronization is indicated as "EXT".
The horizontal phase in the external synchro-
nization is adjusted.
Top screen of SETUP menu
SCENE FILE
WHITE BAL
BLACK BAL
SYNC
ELECTRIC ZOOM
FREEZE
END
H PHASE
RET END
z
Set the synchronizing signal input/output selection
switch on the rear face of the CCU to "IN".
x
Connect the video synchronizing signal to the synchro-
nizing signal output/input connector.
c
Perform the settings of the function setup switches 1
and 2 in accordance with the video format used by the
device to be synchronized. (
v
Move the cursor to "SYNC" on the top screen of the
SETUP menu.
b
Press the [SEL] button after making sure that "EXT"
appears.
The "SYNC" screen appears.
n
Connect the Y or G signal from the RGB/YPbPr output
connector and the video synchronizing input signal to
an oscilloscope, observe the horizontal synchronization
component.
m
Adjust the horizontal phase with use of the [e] or [f]
button.
24
** SET UP ** P2
*FILE1
AWC
*MANU
INT
OFF
OFF
"SYNC" screen
** SYNC **
— .... .... +
|
page 11)
11. Electronic zoom setting [ELECTRIC
ZOOM]
Selection "ON" (default) or "OFF" determines whether or not
to use the electronic zoom.
To prevent the electronic zoom from being active by mis-
take, select "OFF".
When "ON" is selected, assignment of the zoom function to
the [e] and [f] buttons in the SEL menu allows users to
scale up (up to 2.5 times) or scale down a photographic
subject with use of the [e] or [f] button.
Notes:
• Calling up the SETUP menu cancels scale up and
down.
• When "ELECTRIC ZOOM" is set to "OFF", "ZOOM OFF"
appears in the SEL menu, and the zoom function is not
adjustable.

12. Image freezing [FREEZE]

Selection "ON" (default) or "OFF" determines whether or not
to enable the freeze function.
When "ON" is selected, pressing the [FREEZE (MENU)] but-
ton on the front face of the CCU allows users to display the
video currently displayed as a static image. (

Default setting restoring

• When the settings of the level indicators (–....I....+) in
the SETUP menu or SEL menu are reset to the default,
hold down both of the [e] and [f] buttons simultane-
ously for more than 2 seconds.
• When all the settings in the SETUP and SEL menu are
reset to the default, move the cursor to "END" on the
bottom line, and hold down both of the [FREEZE
(MENU)] and [h] buttons simultaneously for more than
2 seconds.
page 9)