Directed Video WFM100 Owner's Installation Manual

Directed video wireless fm transmitter owner's guide/installation guide

Channel Select Switch

88.7, 88.5, 88.3, 88.1 MHz

Power ON

LED

Power

Switch

88.7 88.5 88.3 88.1

I I N N T T R R O O D D U U C C T T I I O O N N

The audio input to the WFM100 can be connected to either the low-level fixed audio output or a variable level

audio output (such as a speaker or headphoen output). If it is connected to a low-level output, only the volume

control on the earphones needs to be adjusted to control the volume level. If it is connected to a variable level

output, the volume level adjustment needs to be done at both the source and at the headphones.

W W I I R R E E H H A A R R N N E E S S S S W W I I T T H H R R C C A A C C O O N N N N E E C C T T O O R R S S

1. Use the dual RCA cable and connect one end to the Red and White jacks. Connect the other end to the low

level signal source. Ensure that you observe the left and right polarity at both ends of the cable.

2. Connect power and ground wire connector to 12Vdc input wires. Connect the Black (-) wiere to the chassis

ground of the vehicle and connect the Red (+) wire (with line fuse) to the power source.

F F C C C C R R F F E E X X P P O O S S U U R R E E C C O O M M P P L L I I A A N N C C E E

This low power transmitter complies with the following standards and guidelines for limiting RF exposure for the

general population/uncontrolled environment. It complies with the following standards and guidelines

FCC 96-326 - Guidelines for evaluating the evironmental effects of radio-grequency radiation.

FCC OET Bulletin 65 Edition 01-01 (2001) Supplement C - Evaluating compliance with FCC guidelines for

human exposure to radio frequency electromagnetic fields.

ANSI/IEEE C95.1 - 1992 - IEEE standard for safety levels with respect to human exposure to radio frequency

electromagnetic fields, 3kHz to 300GHz.

ANSI/IEEE C95.3 - 1992 - IEEE recommended practice for the measurement of potentially hazardous electro-

magnetic fields - RF and microwave.

Wireless FM Transmitter

M M O O D D E E L L W W F F M M 1 1 0 0 0 0

WFM100

Mono/Stereo Switch

RCA Cable

1 1

O O W W N N E E R R ' ' S S G G U U I I D D E E

I I N N S S T T A A L L L L A A T T I I O O N N G G U U I I D D E E

Power Input

Antenna

N86102 09/04

Table of Contents

Need help?

Do you have a question about the WFM100 and is the answer not in the manual?

Page 1 I I N N T T R R O O D D U U C C T T I I O O N N The audio input to the WFM100 can be connected to either the low-level fixed audio output or a variable level audio output (such as a speaker or headphoen output).
Page 2 N N O O N N - - T T R R A A N N S S F F E E R R A A B B L L E E L L I I M M I I T T E E D D C C O O N N S S U U M M E E R R W W A A R R R R A A N N T T Y Y Directed Electronics, Inc.