Installation; Installing The Range Backguards - Electrolux E48DF76EPS - 48" Pro-Style Dual-Fuel Range Installation Instructions Manual

INSTALLING THE 30", 36" & 48" RANGE OPTIONAL
BACKGUARDS
Your Electrolux Icon TM range was shipped with a backguard in place. These
instructions cover the installation of one of the optional backguards.
WARNING WARNING WARNING
WARNING WARNING
Be sure that the range is not connected to gas or power before proceeding.
Installing the Range Optional Backguard:
1. Remove the backguard from its box.
2. To avoid scratches, place small scraps of thin cardboard on the rear of
the side panels where the backguard will make contact. With the
assistance of at least one other person, carefully lift the backguard and
place down on to the range top. Special attention should be given to the
lower flange in front of the backguard, which must fit between the
stainless steel side panels.
3. Fasten the provided screws through the rear flange.
4. Connect the gas line to the regulator. Reposition and attach the access
panel or the back cover if the entire back cover was removed.
5. You are now ready to continue with the range installation.
Figure 11
Backguard Installation
(36" range shown)
NO NO NO NO NOTE TE TE TE TE
For 24" Backguards, fasten the provided screws through the holes in the back panel of
the Backguard.

Installation

Figure 12
Backguard Installation
(48" range shown)
17