7.25
Brightness+ Command
Command
"C20" [CR]
Detail
Brightness of user control +1
Acceptable
Response
Unacceptable
7.26
Brightness- Command
Command
"C21" [CR]
Detail
Brightness of user control -1
Acceptable
Response
Unacceptable
7.27
Image (Toggle) Command
Command
"C27" [CR]
Switch Image setting status.
Detail
This command works the same as the remote control's "Image" button or the
key on the projector body.
Acceptable
Response
Unacceptable
7.28
Power Management Ready Command
Command
"C2A" [CR]
Set Power Management to Ready
Detail
This status is stored in EEPROM, so even if turning off and on.
Acceptable
Response
Unacceptable
7.29
Power Management OFF Command
Command
"C2B" [CR]
Set Power Management to OFF mode.
Detail
This status is stored in EEPROM, and even if turning OFF and ON.
Acceptable
Response
Unacceptable
7.30
Power Management Shut Down Command
Command
"C2E" [CR]
Set Power Management to Shut down mode.
Detail
This status is stored in EEPROM, and even if turning OFF and ON.
Acceptable
Response
Unacceptable
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
[ACK] [CR]
"?" [CR]
Page
12/21