Hayward HeatPro Parts Manual
Heat pro owners operations & parts manual
Hide thumbs
Also See for HeatPro:
- Owner's manual (28 pages) ,
- Installation manual (22 pages) ,
- Owner's manual (43 pages)
Advertisement
Attention
Installer:
Give this manual to
the homeowner.
Important Information to
keep for Service
Model # ___________________
Serial # ____________________
Install Date ________________
The Hayward HeatPro Heat Pump is listed by ETL as complying with the latest edition of the "UL Standard for Safety for
Heating and Cooling Equipment", UL1995 and CSA C22.2 No. 236.
All Hayward HeatPro Heat Pumps must be installed in accordance with all applicable National and Local codes. In the absence
of local codes, refer to the latest edition of the National Electric Code (NEC) in the United States and the Canadian Electric
Code (CEC) in Canada
Basic safety precautions should always be followed, including the following: Failure to follow instructions can cause severe
injury and/or death.
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for one of the
following signal words and be alert to the potential for personal injury.
WARNING
warns about hazards that could cause serious personal injury, death or major property damage and if
ignored presents a potential hazard.
CAUTION
warns about hazards that will or can cause minor or moderate personal injury and/or property damage
and if ignored presents a potential hazard. It can also make consumers aware of actions that are unpredictable and unsafe.
The NOTICE label indicates special instructions that are important but not related to hazards.
Models: HP20654T, HP20654BT, HP20854T,
HP20854BT and HP21104T
OWNERS OPERATION & PARTS MANUAL
SAVE THIS OWNERS MANUAL
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Pomona, CA Clemmons, NC Nashville, TN
HP13023772 Rev: D
Tel: 908.351.5400
www.haywardpool.com
Advertisement
Table of Contents
Related Manuals for Hayward HeatPro
Summary of Contents for Hayward HeatPro
- Page 1 Install Date ________________ SAVE THIS OWNERS MANUAL The Hayward HeatPro Heat Pump is listed by ETL as complying with the latest edition of the “UL Standard for Safety for Heating and Cooling Equipment”, UL1995 and CSA C22.2 No. 236. All Hayward HeatPro Heat Pumps must be installed in accordance with all applicable National and Local codes. In the absence...
- Page 2 (3’) [1 m] apart, as measured from near point to near point. Dual suction outlets shall be placed in such locations and distances to avoid “dual blockage” by a user. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400...
- Page 3 4°F (2.2°C). Persons taking medications, which induce drowsiness, such as tranquilizers, antihistamines or anticoagulants, should not use spas or hot tubs. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400...
-
Page 4: General Information
For weekend use, it is more economical to maintain the pool water temperature at the desired temperature. Hayward Pool Products offers the following recommendations to help conserve energy and minimize the cost of operating the heat pump. - Page 5 Display of self diagnostic codes to monitor heat pump performance; o Control Lock Out Function; o Defrost Function to prevent evaporator coil freeze up; Titanium Heat Exchanger withstands the harshest conditions. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400 www.haywardpool.com...
-
Page 6: How A Heat Pump Works
Exchanger (Condenser) by the pool pump, is heated as it passes through. Becoming Familiar with Your Heat Pump Heat Pump Protection Features Hayward heat pumps are equipped with safeguards that will stop operation to protect the unit in case of the following events: • Excessively high refrigerant pressure •... - Page 7 2 hours (display will show “dEF”). After the 2-hour period, the unit will restart to check the evaporator temperature and try to resume normal operation. The heat pump control will continue this cycle until the evaporator temperature returns to normal. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400...
- Page 8 The troubleshooting section provides recommendations if leaks are suspected. NOTICE: Keep the drain hole clear of debris and clean it regularly to remove any obstruction. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400...
- Page 9 A pool cover that reduces evaporative cooling can reduce the heat lost from a pool by approximately 50% (which also reduces your power consumption by 50%). USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400...
-
Page 10: Start-Up Procedures
HP13023772 Rev: D HEATPRO HEAT PUMP Operating the HeatPro Heat Pump NOTICE- Do not use this heat pump if any part has been flooded or submerged in water. Immediately call a qualified technician to inspect and replace any damaged part of the heat pump. Control System components must be replaced if submerged in water. - Page 11 Page 11 of 22 HP13023772 Rev: D HEATPRO HEAT PUMP Becoming Familiar with HeatPro Heat Pump Controls Up Arrow Button Display Window Down Arrow Button Spa Button (Optional) Pool Button Run Light Heat Pump Control Panel Display Window (All Models)
-
Page 12: Control Operation
Press and release the up or down arrow button once to display the current set To display the set point: point for 3 seconds. For help with this type of control, refer to Troubleshooting Guide with Digital Control. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400 www.haywardpool.com... -
Page 13: Maintenance
DIRECTLY INTO THE SKIMMER. Inspection and Service Hayward HeatPro heat pumps are designed and constructed to provide long performance life when installed and operated properly under normal conditions. Periodic inspections are important to keep your heat pump running safely and efficiently through the years. - Page 14 HP13023772 Rev: D HEATPRO HEAT PUMP Owner Inspection Hayward recommends that you inspect your heat pump on a seasonal basis and especially after significant weather events. Refer to the sections of this Manual: “Clearance”, “Roof Run-Off”, “Drainage and Condensation” for proper inspection.
- Page 15 4. Ensure that the heat pump thermostat is set at a temperature above that of the pool or spa temperature. 5. Ensure the outside temperature is high enough to allow the unit to operate. Hayward heat pumps will not turn on when the outside air temperatures near 50°F (10°C).
- Page 16 If the two temperatures are the same, there may be a problem. Note: Use a solar blanket / cover on the surface of the pool in order to minimize heat loss. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400...
- Page 17 Circuit Breakers: If it is suspected that a circuit breaker is tripped, turn the breaker to the “Off” position and then back to the “On” position. NOTICE: Service to be conducted ONLY by an EPA Certified Service Technician. General Troubleshooting Guide for Hayward HeatPro Heat Pump Problem Possible Cause...
- Page 18 Page 18 of 22 HP13023772 Rev: D HEATPRO HEAT PUMP Display Diagnostic Codes - Troubleshooting Guide for Hayward HeatPro Heat Pump Display Problem Possible Cause Solution No power to heat Tripped circuit breaker/ Check breaker and ensure that the unit is properly...
- Page 19 Page 19 of 22 HP13023772 Rev: D HEATPRO HEAT PUMP Heat Pump Replacement Parts Diagram CONTROL BOX FOR: HP2654T, HP20654BT, HP2854T, HP20854BT & HP21104T USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400 www.haywardpool.com...
- Page 20 SCREW REPLACEMENT KIT (NS) HPX0054 COMPRESSOR MOUNT KIT (NS) HPX10024732 HPX10024289 COMPRESSOR EL. PLUG (NS) HPX01023760 ELECTRICAL ENTRY PLUG HPX11024151 FAN RUN CAPACITOR HPX11024169 DEFROST SENSOR USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400 www.haywardpool.com...
-
Page 21: International Warranty
HAYWARD® HEAT PUMP POOL HEATER LIMITED WARRANTY The HAYWARD heat pump pool heater is warranted to be free of defects in materials and workmanship for a period of two (2) years for parts and (1) one year for labor. In the state of Florida, warranty labor is covered for (2) years. This warranty is applicable to the original location and owner only and is not transferable. - Page 22 Page 22 of 22 HP13023772 Rev: D HEATPRO HEAT PUMP ▼ DETACH HERE: Fill out bottom portion completely and mail within 10 days of purchase/installation. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400 www.haywardpool.com...
Need help?
Do you have a question about the HeatPro and is the answer not in the manual?
Questions and answers