Datacenter-Bridging Priority-Flow-Control Mode On; Datacenter-Bridging Priority-Flow-Control Priority - NETGEAR ProSafe GSM7224P User Manual

dropped frames, while allowing traffic that has greater loss tolerance to continue to flow on
the interface.
Priorities are differentiated by the priority field of the IEEE 802.1Q VLAN header, which
identifies an IEEE 802.1p priority value. In NETGEAR Managed Switch, these priority values
must be mapped to internal class-of-service (CoS) values.
To enable priority-based flow control for a particular CoS value on an interface:
• Ensure that VLAN tagging is enabled on the interface so that the 802.1p priority values
are carried through the network.
• Ensure that 802.1p priority values are mapped to IEEE 802.1Q CoS values.
• Use the datacenter-bridging priority-flow-control mode on command to enable
priority-based flow control on the interface.
• Use the datacenter-bridging priority-flow-control priority command to specify the CoS
values that should be paused ("no-drop") due to greater loss sensitivity. Unless
configured as "no-drop," all CoS priorities are considered nonpausable ("drop") when
priority-based flow control is enabled.
When priority-flow-control is disabled, the interface defaults to the IEEE 802.3x flow control
setting for the interface. When priority-based flow control is enabled, the interface will not
pause any CoS unless there is at least one no-drop priority.

datacenter-bridging priority-flow-control mode on

Use this command to enable priority-based flow control on an interface.
Format
datacenter-bridging priority-flow-control mode on
Mode
Interface Config
Default
Disabled
no datacenter-bridging priority-flow-control mode
Use this command to disable priority flow control on an interface.
Format
no datacenter-bridging priority-flow-control
Mode
Interface Config

datacenter-bridging priority-flow-control priority

Use this command to specify the priority group(s) that should be paused when necessary to
prevent dropped frames; i.e., the group to receive priority flow control. This configuration has
no effect on interfaces not enabled for priority flow control.
VLAN tagging must be enabled to carry the 802.1p value through the network. The number of
lossless priorities supported on XSM7224S is 2.
ProSafe Managed Switch
Switching Commands
221