Routing Configuration
This section describes configuration scenarios and instructions for the following routing features:
•
"VLAN Routing" on page 67
•
"Virtual Router Redundancy Protocol" on page 70
•
"Proxy Address Resolution Protocol (ARP)" on page 73
•
"OSPF" on page 74
•
"Routing Information Protocol" on page 84
•
"Route Preferences" on page 87
•
"Loopback Interfaces" on page 90
•
"IP Helper" on page 92
VLAN Routing
This section provides an example of how to configure PowerConnect M6220/M6348/M8024 switch
software to support VLAN routing.
NOTE:
The management VLAN cannot be configured as a routing interface. The switch may also be managed
via VLAN routing interfaces.
CLI Examples
The diagram in this section shows a Layer 3 switch configured for VLAN routing. It connects two
VLANs, with two ports participating in one VLAN, and one port in the other. The script shows the
commands you would use to configure PowerConnect M6220/M6348/M8024 switch software to
provide the VLAN routing support shown in the diagram.
Routing Configuration
4
67