Troubleshooting - Yamaha PocketrakCX - POCKETRAK CX 2 GB Digital Player Reference Manual

Troubleshooting

The unit does not operate.
Possible cause
Corrective action
Buttons do not work.
Possible cause
Corrective action
Possible cause
Corrective action
The eneloop cannot be recharged from the connected computer.
Possible cause
Corrective action
Possible cause
Corrective action
Icon " " appeared when you attempted to recharge the battery.
Possible cause
Corrective action
Possible cause
Corrective action
The unit does not recognize the inserted microSD card.
Possible cause
Corrective action
Possible cause
Corrective action
POCKETRAK CX Reference Manual
Battery is not inserted properly or is exhausted.
Reinsert the battery correctly.
Recharge the eneloop or replace with a new alkaline battery (see
The Hold function is set.
Set the [HOLD/CHARGE] switch (located on the rear panel of the unit) to
its original position to cancel the Hold function.
The USB terminal is still connected to the computer.
Disconnect the unit from the computer (see
The BATTERY SET is set to "ALKALINE."
Set the BATTERY SET to "eneloop" (see
The [HOLD/CHARGE] switch is not set correctly.
Set the [HOLD/CHARGE] switch to [HOLD
• You attempted to recharge a battery other than the eneloop.
• You attempted to recharge the battery, but no battery was inserted.
• The eneloop is not inserted correctly.
Insert the eneloop battery into the unit.
The unit is overheated.
Disconnect the unit from the PC, let the unit cool down for a while, then
try to recharge again.
The microSD card is not inserted correctly.
Turn off the power to the unit, then insert the microSD card correctly.
The microSD card was formatted on a computer or device other than the
recorder.
Use the POCKETRAK CX to format the microSD card (see
page 55).
page 51).
].
w
page
Appendix
page 71).
46).
74