Data Display; About Display - NorthStar EXPLORER 443D Installation And Operation Manual

Economy is the distance travelled per unit of fuel
used. The Fishfinder calculates this using the fuel
used and boat speed (water speed or GPS speed
- which ever is selected as the speed source – see
section 3-3 Setup > Fuel).

5-8 Data display

5-9 About display

28
To show the Data display, press DISP and select Other Tab, select
Data and press ENT.
This shows a graph of the water temperature and depth over the last
20 minutes and selected data items.
The graph is useful for locating warm and cold spots in the water.
To change data items:
1. Press MENU until the Options menu is shown.
2. Highlight Data setup and press ENT.
3. Use the cursor keys to move from data field to data field.
4. Press ENT at any data field to show the list of data items that can
be displayed there.
5. Highlight the required data item and press ENT. The data item is
immediately displayed.
6. Press ESC when finished.
Time base of graph can be changed by pressing Menu, selecting
Time Base with cursor key, pressing ENT, and selecting the required
time base from list - 5min, 10min, 20min, 1hr, 2hr.
To show the About display, press DISP, select Other Tab, select
About and press ENT.
There are no options.
This shows the fishfinder model number, the software and hardware
versions and wiring information.
Note the software version before contacting your Northstar dealer
for technical advice.
For more information on wiring, see section 6-5 Wiring options.
For more information on NMEA and NavBus, see section 6-6 Systems
of several instruments.
Northstar Explorer 443d/443df Installation and Operation Manual
The bigger this number, the better the fuel
economy. Adjust the throttle and trim to achieve
the best fuel economy.
Note: when water speed is selected as the
speed source, calibration of the boat speed
measurement is essential for an accurate fuel
economy reading – see section 3-8 Setup >
Calibrate.