Operating Constraints; Server Support - HP 4000/6000/8000 Release Note
Enterprise virtual array connectivity 5.1a for windows
Hide thumbs
Also See for 4000/6000/8000:
- Reference manual (456 pages) ,
- Release note (9 pages) ,
- Reference (39 pages)
Table of Contents
Advertisement
Server support
Windows supports ProLiant servers, including Blade Servers and HP Integrity Servers.
Operating constraints
For information about operating constraints for the EVA4000/6000/8000 hardware and HP
StorageWorks Command View EVA, see their release notes.
SAN boot procedures
Booting from the SAN is supported for Windows 2000 and Windows 2003 for multipath configurations.
SAN boot procedures are available on the following HP web site:
http://h18000.www1.hp.com/products/storageworks/san/documentation.html
Failover/failback
Failback preference settings for the HSV controllers are specific to the operating system. See the HP
StorageWorks Windows connectivity for the Enterprise Virtual Array installation and reference guide
for more information.
Storage System Scripting Utility for EVA
The latest version of the Storage System Scripting Utility (SSSU) is available on the HP storage web site:
http://h18006.www1.hp.com/products/storage/software/cmdvieweva/index.html
Recommendations
This section contains HP recommendations to ensure proper operation of the EVA4000/6000/8000
storage system.
Codeload usage
When a system with a maximum configuration is running at full capacity, it may experience a time-out
condition before codeload is complete. HP recommends that you always upgrade multipathing software
at an off-peak time.
Disk resource Pending Timeout for large configurations
To ensure continuous operation of disk resources across the SAN with disk resource counts greater
than 8, HP recommends that you increase the Pending Timeout value for each disk resource from
180 seconds to 360 seconds.
To set the Pending Timeout value:
1.
Open the Microsoft Cluster Administrator.
2.
Select a Disk Group resource in the left pane.
3.
One at a time, right-click each Disk Resource in the right pane and select Properties.
4.
Click the Advanced tab.
5.
Change the Pending Timeout value to 360.
6.
Click OK.
4000/6000/8000 Enterprise Virtual Array connectivity 5.1A for Windows release notes
9
Advertisement
Table of Contents
