Configuring A Local Server Using Acu Located On A Remote Server - HP 166207-B21 - Smart Array 5302/32 RAID Controller Reference Manual

The Configuration screen appears.
Configure the controller:
7.
To configure manually, see "Performing a Configuration task (on page 42)."
o
To configure with a wizard, see "Using Wizards (on page 51)" or "Using Express Configuration
o
(on page 52)."
When prompted, save the configuration.
8.
Do one of the following:
9.
To configure an additional controller, repeat steps 6 through 8.
o
Click Exit ACU.
o
To operate ACU on this server in Local Application mode, do the following:
10.
Click Start, and then select Programs>HP System Tools>HP Array Configuration Utility>Setup HP
a.
Array Configuration Utility.
When the Execution Mode screen appears, select Local Application Mode.
b.
Reboot the server.
c.
(Optional) To make newly created logical drives available for data storage, use the operating system
11.
disk management tools to create partitions and format the drives.
Configuring a local server using ACU located on a remote
server
On the server where ACU is installed, click Start, and then select Programs>HP System Tools>HP
1.
Array Configuration Utility>Setup HP Array Configuration Utility.
The Execution Mode screen appears.
If Remote Service Mode is selected, continue with step 2.
o
HP Array Configuration Utility 24