Dell 8 Getting Started Manual page 9

Using the CMC GUI to set the IP address
To change the IP address, use the following steps:
1. Open the CMC application's Setup tab.
2. Enter the new information in the IP Address, Subnet Mask, and Gateway fields as appropriate and click Apply.
3. To enable DHCP, select DHCP Enabled and click Apply.
FIGURE 1 CMC Setup Tab
NOTE
Refer to the application for additional detail.
Connecting the FC SAN Module to the Ethernet network
Once you have successfully set the appropriate IP address of the FC SAN Module, you can establish an Ethernet
connection through the Chassis Management Controller (CMC) to a remote management workstation for any
additional configuration. The management workstation must be on the same Ethernet subnet as the CMC.
NOTE
Ensure that the FC SAN Module is not being modified from any other connection until configuration is complete.
Dell 8/4Gbps FC SAN Module Getting Started Guide 7
53-1001963-01