Adjusting The Camera Position; Mounting The Camera - JVC VN-T216VPRU Instructions Manual

Adjusting the Camera Position

Mounting the Camera

The dome camera has three axes for positioning the camera. While
monitoring the picture on the monitor, adjust the camera position as follows:
Ÿ
Pan Adjustment (A) For Wall Mount and Tilted Ceilings Rotate the lens
base (maximum360° ) until you are satisfied with the field of view.
Ÿ
Horizontal Rotation (B) Rotate 3D assembly in the base. Do not turn
assembly more than 360° as this assembly may cause the internal
cables to twist and disconnect or break.
Ÿ
Tilt Adjustment (C) After loosening the thumbnuts, position the camera as desired,
then finger –tighten the thumbnuts to set the position.
Do not turn the lens more than 360° as this may cause internal
Caution
cables to disconnect or break.
Caution Retighten the locking screws to prevent loss of adjustment.
Ÿ
Place the guide pattern sticker (supplied) on the mounting surface and
mark three holes according to the guide pattern sticker. Then fasten the
sticker to the mounting surface with screws.
Ÿ
Connect the Safety Wire (Fall Prevention Wire, not supplied) to the
camera and the ceiling.
A
B
C
11