1. Manuals
  2. Brands
  3. Desa Manuals
  4. Heater
  5. RM30LP
  6. Owner's manual

Desa RM30LP Owner's Manual

Desa owner's manual propane construction heater rm30lp
Hide thumbs
Table of Contents

Advertisement

Quick Links

CONSTRUCTION
IMPORTANT: Read and understand this manual before assembling, starting, or
servicing heater. Improper use of heater can cause serious injury. Keep this
manual for future reference.
GENERAL HAZARD WARNING: FAILURE TO COMPLY WITH THE PRECAU-
TIONS AND INSTRUCTIONS PROVIDED WITH THIS HEATER, CAN RESULT IN
DEATH, SERIOUS BODILY INJURY AND PROPERTY LOSS OR DAMAGE FROM
HAZARDS OF FIRE, EXPLOSION, BURN, ASPHYXIATION, CARBON MONOXIDE
POISONING, AND/OR ELECTRICAL SHOCK.
ONLY PERSONS WHO CAN UNDERSTAND AND FOLLOW THE INSTRUCTIONS
SHOULD USE OR SERVICE THIS HEATER.
IF YOU NEED ASSISTANCE OR HEATER INFORMATION SUCH AS AN INSTRUC-
TIONS MANUAL, LABELS, ETC. CONTACT THE MANUFACTURER.
PROPANE
HEATER
OWNER'S MANUAL
RM30LP

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RM30LP and is the answer not in the manual?

Questions and answers

Related Manuals for Desa RM30LP

Summary of Contents for Desa RM30LP

  • Page 1 HAZARDS OF FIRE, EXPLOSION, BURN, ASPHYXIATION, CARBON MONOXIDE POISONING, AND/OR ELECTRICAL SHOCK. ONLY PERSONS WHO CAN UNDERSTAND AND FOLLOW THE INSTRUCTIONS SHOULD USE OR SERVICE THIS HEATER. IF YOU NEED ASSISTANCE OR HEATER INFORMATION SUCH AS AN INSTRUC- TIONS MANUAL, LABELS, ETC. CONTACT THE MANUFACTURER. HEATER RM30LP...

  • Page 2: Safety Information

    30,000 BTU/Hr PROPANE CONSTRUCTION HEATER SAFETY INFORMATION WARNINGS WARNING: FIRE, BURN, IN- HALATION, AND EXPLOSION HAZARD. KEEP SOLID COMBUS- TIBLES, SUCH AS BUILDING MA- TERIALS, PAPER OR CARD- BOARD, A SAFE DISTANCE AWAY FROM THE HEATER AS RECOMMENDED BY THE IN- STRUCTIONS.

  • Page 3: Product Identification

    PRODUCT IDENTIFICATION Hot Air Outlet (Front) Piezo Ignitor Button Automatic Control Valve Button Figure 1 - 30,000 BTU/Hr Model FUNDAMENTALS OF OPERATION The Fuel System: The hose/regulator assembly attaches to the propane gas sup- ply. This provides fuel to the heater. The Air System: The motor turns the fan.

  • Page 4: Propane Supply

    30,000 BTU/Hr PROPANE CONSTRUCTION HEATER ASSEMBLY 1. Remove screw from top of fan guard. Discard screw. 2. Insert nut clip (provided with handle) with flat side facing up through slot in top of shell. Align holes in nut clip with screw hole behind slot in top of shell.

  • Page 5: Operation

    VENTILATION WARNING: Provide at least a one square foot opening of fresh, outside air while running heater. If proper fresh, outside air venti- lation is not provided, carbon monoxide poisoning can occur. Provide proper fresh, outside air ventilation before running heater. 105343 OWNER’S MANUAL OPERATION...

  • Page 6: Maintenance

    30,000 BTU/Hr PROPANE CONSTRUCTION HEATER STORAGE CAUTION: Disconnect heater from propane supply tank(s). 1. Store propane tank(s) in safe manner. See Chapter 5 of Standard for Storage and Handling of Liquefied Petroleum Gases, ANSI/NFPA 58. Follow all lo- cal codes. Always store propane tanks outdoors.

  • Page 7: Troubleshooting

    TROUBLESHOOTING Note: For additional help, visit DESA International’s Technical Service web site at www.desatech.com. OBSERVED FAULT Fan does not turn when heater is plugged in. Heater will not ignite. Heater shuts down while running. 105343 OWNER’S MANUAL WARNING: Never service heater while it is plugged in, connected to propane supply, operating, or hot.

  • Page 8: Service Procedures

    30,000 BTU/Hr PROPANE CONSTRUCTION HEATER SERVICE PROCEDURES You can also visit DESA International’s Technical Service web site at www.desatech.com. WARNING: Never service heater while it is plugged in, con- nected to propane supply, oper- ating, or hot. Severe burns and electrical shock can occur.
  • Page 9 SERVICE PROCEDURES Continued 1. Remove three screws that attach fan guard to heater shell. 2. Remove motor and fan guard from heater shell (see Figure 13). 3. Use hex wrench to loosen set screw that holds fan to motor shaft (see Figure 14). 4.
  • Page 10 30,000 BTU/Hr PROPANE CONSTRUCTION HEATER SERVICE PROCEDURES Continued IGNITOR 1. Remove motor and fan guard from heater (see Motor, page 8, steps 1 and 2). 2. Remove black ignitor wire from piezo ignitor. Access ignitor wire through un- derside of heater base (see Figure 16). Push wire up through notch in filler panel.

  • Page 11: Replacement Parts

    If they can not supply an accessory or part, either con- tact your nearest Parts Central (listed in the separate Authorized Service Center book- let) or contact DESA International for refer- ral information. DESA International P.O. Box 90004...

  • Page 12: Illustrated Parts Breakdown

    30,000 BTU/Hr PROPANE CONSTRUCTION HEATER ILLUSTRATED PARTS BREAKDOWN RM30LP 105343...

  • Page 13: Parts List

    PARTS LIST RM30LP PART 104154-01 104152-01 M11143-1 M11084-27 099237-01 103894-01 104162-01 M11084-38 101478-02 104156-01 103863-01 097384-02 101480-12 104786-01 101732-05 103895-01 098219-17 104146-01 104144-01 102445-01 104153-01 M12461-14 097941-31 104161-01 104160-01 LPA3120 LPA4020 105343 This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacement Parts on page 11 of this manual.

  • Page 14: Warranty And Repair Service

    WARRANTY AND REPAIR SERVICE DESA International warrants this product and any parts thereof, to be free from defects in materials and workmanship for one (1) year from the date of first purchase when operated and maintained in accordance with instructions. This warranty is extended only to the original retail purchaser, when proof of purchase is provided.

Table of Contents

Save PDF