Before using your DIRECTV Universal Remote Control, you may need to program it to operate with your particular component. Please follow the instructions detailed in this guide to set up your DIRECTV Universal Remote Control so you can start enjoying its features.
FEATURES AND FUNCTIONS Key Charts Press this key… To… Slide the MODE switch to the DIRECTV, AV1, AV2 or TV positions to select the component you want to control. A green LED under each switch position indicates the component being controlled.
Page 5
Guide and menu screens. Press BACK to return to the previously displayed screen. Press MENU to display the Quick Menu in DIRECTV mode, or other menu for another selected device. Use INFO to display current channel and program information when watching live TV or in the Guide.
Press this key… To… Press PREV to return to the last channel viewed. Press the number keys to directly enter a channel number (e.g. 207) while watching TV or in the Guide. Press DASH to separate main and sub- channel numbers. Press ENTER to activate number entries quickly.
CONTROLLING YOUR TV Once you have successfully set up your DIRECTV Remote to operate your DIRECTV Receiver, you can set it up to control your TV. We recommend you use the on-screen steps described on page 7, but you can also use the manual method below: Turn on the TV.
TV in the blocks below: SETTING UP THE TV INPUT KEY Once you have setup the DIRECTV Remote control for your TV, you can activate the TV INPUT key so you can change the “source”—the piece of equipment whose signal is displayed on your TV: Slide the MODE switch to the TV position.
Locate the 5-digit code for your component. (See “Setup Codes, Other Devices” starting on page 14.) Slide the MODE switch to the AV1 (or AV2) position. Press and hold the MUTE and SELECT keys at the same time until the green light under AV1 (or AV2) flashes twice, then release both keys.
TV or component. Verifying the Codes Once you have set up the DIRECTV Universal Remote Control using the above steps, use the following instructions to find out the 5-digit code to which your component responded: Slide the MODE switch to the appropriate position.
SOLUTION 1: Try replacing the batteries (see page 6). ® SOLUTION 2: Make sure you are aiming the DIRECTV Universal Remote Control at your home entertainment component and that you are within 15 feet of the component you are trying to control.
Page 12
PROBLEM: Changing channels does not work properly. SOLUTION: If original remote control required pressing ENTER to change channels, press ENTER on the DIRECTV Universal remote control after entering a channel number. PROBLEM: Remote control does not turn on Sony or Sharp TV/VCR Combo.
DRD485RGA, DRD435RH, DRD455RH, and DRD486RH Samsung model SIR-S60W 01109 Samsung models SIR-S70, 01108 SIR-S75, SIR-S300W, and SIR-S310W Sony models (All models 01639 except TiVo and Ultimate Setup Codes for DIRECTV HD Receivers DIRECTV all models 00001, 00002 Hitachi model 61HDX98B 00819...
DIRECTV will, at our sole discretion, repair or replace the DIRECTV Universal Remote Control, provided that: a. You are a customer of DIRECTV and your account is in good standing; and b. The problem with the DIRECTV Universal Remote Control...
This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. Responsible Party: DIRECTV, Inc. 2230 E. Imperial Hwy. El Segundo, CA 90245 1-800-531-5000 FCC ID #: MG3 2081...
Need help?
Do you have a question about the RC23 and is the answer not in the manual?
Questions and answers