Pittsburgh 93645 Instructions

Torque Multiplier/
Lugnut Remover
Safety Precautions and Instructions
READ AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS BEFORE USE.
©
Copyright 2005 by Harbor Freight Tools
contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools.
1. Always wear ANSI approved safety goggles
during use.
2. Do not force the tool. Use the correct tool for
your application. The correct tool will do the job
better and safer at the rate for which it is designed.
Do not force the tool and do not use the tool for a
purpose for which it is not intended. This tool is
designed explicitly to help remove or tighten
Lugnuts. It should not be used for any other purpose,
because improper mounting could result in the unit
coming loose under load, causing severe personal
injury or property damage.
3. Verify that the socket and the support completely
and securely fit over both lugnuts before use.
4. After this tool is used, a torque wrench (not
included) must also be used to verify that the
lugnuts are properly tightened in place.
5. DO NOT OVERTIGHTEN. NEVER use this tool to
tighten a nut/bolt above its torque specification.
6. Before every use, check for any broken parts or
mounting fixtures, and any other condition that
may affect proper operation. Any part that appears
damaged should be carefully checked to determine
that it will operate properly and perform its intended
function. Do not use if any socket is worn, cracked,
or chipped.
7. Stay alert. Watch what you are doing, use common
sense. Do not use this tool if you are tired.
SAVE THIS INSTRUCTION SHEET.
93645
®
TO PREVENT SERIOUS INJURY,
3491 Mission Oaks Blvd./Camarillo, CA 93011
®
. All rights reserved. No portion of this instruction sheet or any artwork
For technical questions, please call 1-800-444-3353.
General Safety Rules
8. Do not use this tool if under the influence of
alcohol or drugs. Read warning labels if taking
prescription medicine to determine if your judgment
or reflexes are impaired while taking drugs. If there
is any doubt, do not use this tool.
9. Replacement par ts and accessories. When
servicing, use only identical replacement parts. Use
of any other parts is dangerous and will void the
warranty. Only use accessories intended for use with
this tool. DO NOT USE ANY DIFFERENT
HANDLES OR SOCKETS WITH THIS TOOL;
sockets/handles not designed for this tool may
break or cause the unit to become unstable,
causing personal injury or property damage.
10. This unit may cause some cosmetic damage to
the rim during normal use.
11. Keep bystanders, children, and visitors away
while operating a power tool. Distractions can
cause you to lose control. Protect others in the work
area from debris such as chips and sparks. Provide
barriers or shields as needed.
The warnings, cautions, and instructions
discussed in this instruction sheet cannot cover
all possible conditions and situations that may
occur. It must be understood by the operator
that common sense and caution are factors
which cannot be built into this set, but must be
supplied by the operator.
(Operation on Back.)