Shutdown; Source Selection - HP L1744A User Manual

Shutdown

1. Press the Power button on
the projector or remote
control. The Power button
flashes and the lamp shuts
down, the fans continue to
run for approximately 2
minutes to cool down the
projector.
To protect the lamp, the projector
will not respond to any commands
during the cooling process.
2. Disconnect the power cord from the wall socket.
Do not unplug the power cord before the projector shutdown sequence is complete or during
the 2-minute cooling down process.
If the projector is not properly shut down, and you attempt to restart it soon after, the fans may
run for a few minutes to cool down. Press Power again to start the projector after the fans
stop.

Source Selection

To sequentially select input sources,
press source on the projector con-
trol panel or the remote control. It
may take you a few seconds when
the projector is searching for input
signals. The selected source will be
displayed at the bottom right of the
screen for 3 seconds. For a quick
search, you can also press the key
repeatedly until your desired signal is
displayed.
5. Operation 21